Controls And Operation - MoistAir HD1407 Oak Manual Del Proprietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Wipe off excess water from the bottle.
Position the water bottle back into the unit by
grasping the water bottle handle and
lowering it gently into the cabinet until the
bottle sits on pads at bottom of cabinet. The
"Side-Fill Cap" must be facing the rear of the
cabinet. When positioned properly, the
plunger will open and water will flow into the
cabinet. The water level will automatically
remain at approximately 1/2" until the bottles
are empty. Allow the filter to saturate for 30 minutes before operation.

Controls and Operation

Where you set your desired humidity levels
depends on your personal comfort level,
outside temperature and inside
temperature. A starting set point of 30%
to 40% ROOM humidity is recommended
but there may be conditions that require a
different setting.
NOTE: If excessive condensation occurs,
reduce fan to a lower speed setting.
To Operate the Controls
Digital Display
Press the power button once to turn
the unit on*. Initially there is a slight
delay while the electronics calibrate.
Two bars (- -) appear during this time.
Once calibration is complete a ROOM
humidity reading between 20% - 95%
will be displayed. A flashing 20 display
indicates that the room humidity is less
than 20%.
NOTE: The default settings at initial startup are (LOW) F1 fan speed and 65%
SET humidity. After desired settings are selected by the user, they remain as long
as the unit remains plugged in and there is no power
interruption. When the unit is unplugged, the original
default settings are reinstated.
Speed Button
This humidifier is equipped with a 3-speed fan control.
Initially pressing the speed button will display the
current speed setting. Each push of the speed button
advances the mode through the settings of (HIGH)
F3, (MEDIUM) F2 , (LOW) F1 and A (AUTO).
Humidifier fan should operate at initial startup. If it does not, refer to "Fan not operating
*
(digital display is illuminated)" in the Troubleshooting section of this manual.
For Reference Only
When Outdoor
Temperature is
F
-10°
-24°
-18°
10°
-12°
20°*
* or higher
7
Recommended
Indoor Relative
:
Humidity (RH) is
C
20%
25%
30%
-6°*
35%*

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hd1409 brushed nickel

Tabla de contenido