Care And Cleaning; Hob; Hob Frame; Fixing Malfunctions - NEFF ND30 Serie Instrucciones De Uso

Care and cleaning

The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition

Hob

Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cool enough
before attempting to clean it.
Only use cleaning products specifically designed for hobs.
Follow the instructions provided on the packaging.
Do not use:
Undiluted washing-up liquid
■
Dishwasher detergent
■
Abrasive products
■
Corrosive products such as oven sprays or stain removers
■
Sponges that may scratch
■
High-pressure or steam cleaners
■

Fixing malfunctions

Malfunctions are usually due to small details. Before calling the
Technical Assistance Service, you should consider the
following advice and warnings.
Indicator Malfunction
none The electric power supply has been cut off. Use other electrical appliances to check whether there has been a
The appliance has not been correctly con-
nected following the connection diagram.
Electronic system malfunction.
The control panel is damp or an object is
flashes
"
resting on it.
Electronic system malfunction.
"§ + number /
+ number /
š
¡ + number
There is an internal error in the working.
/
"‹ "Š
The electronic system has overheated and
"ƒ / "†
the corresponding hotplate has been
switched off.
The electronic system has overheated and
"...
all hotplates have been switched off.
Supply voltage outside normal operating
—‚
limits.
The hotplate has overheated and has
/
—ƒ —„
switched off in order to protect its cooking
surface.
* If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.
24
The best way to remove stubborn stains is to use a glass
scraper. Follow the manufacturer's instructions.
Suitable glass scrapers can be obtained through the Technical
Assistance Service or from our online shop.

Hob frame

In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
■
Solution
power cut.
Check that the appliance has been connected correctly according to
the connection diagram.
If in the above checks, the malfunction is not resolved, contact the
Technical Assistance Service.
Dry the control panel area or remove the object.
Unplug the hob from the mains. Wait about 30 seconds before plug-
ging it in again. *
Unplug the hob from the mains. Wait about 30 seconds before plug-
ging it in again. *
Wait until the electronic system has cooled down completely. Then
push any symbol on the hob.*
Please contact your electricity board.
Wait until the electronic system has cooled down sufficiently before
switching it back on.