Time Programming Function; Turning Off A Hotplate Automatically; The Timer; Cleaning Lock - NEFF ND30 Serie Instrucciones De Uso

Time programming function

This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■

Turning off a hotplate automatically

The zone turns off automatically once the selected time has
elapsed.
Program the cooking time.
The hob must be switched on.
Select the desired hotplate and power level.
1.
Press the symbol. The
3
2.
up. is displayed on the time program function display.
‹‹
Press the + or - symbol. The basic setting appears:
3.
+ symbol: 30 minutes.
- symbol: 10 minutes.

Press the + or - symbol until the desired cooking time
4.
appears.
After a few seconds, the cooking time begins to count down.
Note: The same cooking time can be automatically
programmed for the all the hotplates. The programmed time
passes independently for each of the hotplates.
The Basic settings chapter provides information on
automatically programming the cooking time.

Cleaning lock

Cleaning the control panel while the hob is on may change the
settings.
In order to avoid this, the hob has a cleaning lock function.
Press the symbol. A beep sounds. The control panel is
"
locked for approximately 35 seconds. The surface of the

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.
22
indicator on the hotplate lights
x

"
Changing or cancelling the time
Select the hotplate and press the
Change the cooking time using the + or - symbols, or set
to .
‹‹
Once the time has elapsed
The hotplate switches off. A warning signal sounds.
on the hotplate and
program function display. The
Pressing the
beep.
Notes
If cooking times have been programmed for various zones,
■
the time program function displays the shortest cooking time.
Select a hotplate to check the remaining cooking time.
Any cooking time can be programmed for up to 99 minutes.
■

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
Press the symbol
1.
appears on the time program function display.
Press the + or - symbol. The basic setting appears.
2.
+ symbol: 10 minutes.
- symbol: 5 minutes.
Set the required time using the + or - symbol.
3.
After a few seconds, the timer will start to count down.
Changing or cancelling the time
Press the symbol
time with the + or - symbols, or set to
Once the time has elapsed
A warning signal sounds.
function display and the
Press the
3
and the beep stops.
control panel can now be cleaned without risk of changing the
settings.
Note: The lock does not affect the
The hob may be switched off when desired.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
and selected power level (from 1 to 10 hours).
‰
symbol.
3
appears for 10 seconds on the time
‹‹
indicator flashes.
x
3 symbol turns off the indicators and stops the
3 until the indicator
until the indicator
3 S
‹‹
appears on the time program
‹‹
indicator flashes.
S
symbol. After 10 seconds the indicators go out
" symbol or the main switch.
appears
‹
S lights up. ‹‹
lights up. Change the
.