Miele UBS W1/G Instrucciones De Montaje página 15

M.-Nr. 09813684
Risk of injury due to protruding parts
WARNING

Some components may have protruding parts.
Risk of injury due to protruding parts!
A
Protective goggles should be worn.
Building-under cover plate installation
Removing the lid
A
Remove the 2 top screws from the rear panel, see Fig. 2.
The fixing screws will be required later for fitting the cover plate.
A
Appliances with retaining brackets: Remove the retaining brackets together with the lid, see Fig. 2.
Appliances with retaining brackets: The retaining brackets are no longer required.
A
All appliances: Push a screwdriver into the centre of the stopper and pull the stopper out, see Fig. 3.
A
Loosen the screws by a maximum of five turns.
A
When the screw protrudes, push it back in again.

The clip releases.
A
Lift the lid at the front, slide it to the rear and remove it.
Positioning the ferrite WPS
Only carry out this step if the appliance has a ferrite WPS.
A
Position the ferrite WPS (1), see Fig. 4.
Fitting the adapter
Only carry out this step for appliances with cable holders at the front of the detergent drawer, see Fig. 5.
If the appliance does not have a cable holder at the front of the detergent drawer, the adapter is not required for this
conversion.
A
Remove the cable holder (1), see Fig. 5.
A
Fit the adapter (2) on the ridge on the detergent drawer, see Fig. 5.
Applying sealing strips
A
Cut one of the long sealing strips (A) as appropriate and stick it on the underside of the cover plate (B), see Fig. 6.
A
Attach the remaining long sealing strips on the side panels, rear panel and the edges of the transverse strut,
see Fig. 7.
A
Attach the short sealing strips over the suspension spring holders, see Fig. 8.
Fitting the cover plate
A
Lay the cover plate on the appliance from the front to the rear. At the same time hook the 4 lugs on the cover plate in
the fascia panel, see Fig. 9 (A).
A
To align the fascia panel, press on the cover plate and push it back, see Fig. 9 (B).

There should be no gap between the fascia panel and the appliance.
A
Fasten the cover plate at the front with the 4 screws (1) and washers in the kit. Ensure that each washer is fitted such
that the sealing surface faces the cover plate, see Fig. 10.
A
Fasten the back of the cover plate to the rear panel with the screws (2), see Fig. 10.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
15 von 51
25.08.2020