Miele UBS W1/G Instrucciones De Montaje página 24

24 von 51
A
When the raised-head screw protrudes, push it back in again.

The clip releases.
A
Lift the lid at the front, slide it to the rear, and remove it.
Positioning the WPS ferrite core
This step is only for models with a WPS ferrite core.
A
Position the WPS ferrite core (1); see Fig. 4.
Installing the adapter
Only carry out this step in models with cable holders at the front of the dispenser drawer; see Fig. 5.
If the machine does not have cable holders at the front of the dispenser drawer, the adapter is not required for this
conversion.
A
Remove the cable holders (1); see Fig. 5.
A
Install the adapter (2) on the dispenser drawer; see Fig. 5.
Attaching the sealing strips
A
Cut one of the long sealing strips (A) and stick it on the underside of the cover plate (B); see Fig. 6.
A
Attach the remaining long sealing strips on the side panels, rear panel and the edges of the transverse strut;
see Fig. 7.
A
Attach the short sealing strips over the suspension spring holders; see Fig. 8.
Cover plate installation
A
Lay the cover plate on the machine, front to back. Hook the 4 clips on the cover plate into the fascia panel;
see Fig. 9, Item A.
A
To align the fascia panel, press on the cover plate and push it back; see Fig. 9, Item B.

There should be no gap between the fascia panel and the machine.
A
Secure the front of the cover plate using the 4 screws (1) and washers provided in the conversion kit. Install the
washers so that the sealing side is touching the cover plate; see Fig. 10.
A
Secure the back of the cover plate to the rear panel with the screws (2); see Fig. 10.
Machine installation
NOTE
The  symbol on the cover plate means, "Caution: Hot surfaces."
A
Operate the machine only when it is installed under a countertop.
A
To protect soft or delicate flooring, place the machine on skis (1); see Fig. 11.

Skis will make installation easier and protect the floor.
A
Install the machine, connect it in accordance with the operating instructions, and slide it under the countertop.
A
Carry out appropriate safety tests.
en-US
es
25.08.2020 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 09813684