Location - Hoshizaki DIM-40DE-HC Manual De Instrucciones

ENGLISH
Remove shipping carton, tape(s) and packing. If packing material is left in the ice dispenser, it
will not work properly.
1) After removing the packaging, make sure that the ice dispenser is
in good condition. If in doubt, please do not use the ice dispenser
and contact a professionally qualified person.
2) Remove the protective plastic film from the exterior. If the ice
dispenser is exposed to the sun or to heat, remove the film after
the ice dispenser cools.
3) Remove the package containing the accessories. Check the
contents according to "2. ACCESSORIES".
4) Unscrew and lift off the front panel.
5) Remove the shipping tape holding the bin control switch inside.

4. LOCATION

This ice dispenser is not intended for outdoor use.
The ice dispenser should not be located next to ovens, grills or other high heat producing
equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
To avoid a hazard due to instability of the appliance, the location should provide a firm and
level foundation for the ice dispenser.
Do not place anything on top of the ice dispenser or in front of the louver.
The recommended operating ambient temperature is within 1°C to 40°C. But this ice dispenser
is capable of operating at 43°C. Water connection is cold water only. Operation of the ice
dispenser, for extended periods, outside of these normal temperature ranges may affect
production capacity.
Allow the clearance specified below for proper air circulation
and ease of maintenance and/or service should they be
required.
In some high humidity environments, condensation may form inside the machine and drip onto
the floor. Do not install where the floor can be affected by water.
Avoid prolonged exposure of the appliance to direct sunlight.
NOTICE
WARNING
NOTICE
IMPORTANT
4
Bin Control
Switch
Front Panel
Screw
Top
Side View
20cm
Front
ICE
DISPENSER
Rear
10cm