Publicidad
Idiomas disponibles
Idiomas disponibles
• When operating a charger outdoors, always provide a dry location and use an extension cord suitable for
outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
Do not operate the charger if it has received a sharp blow, been dropped or otherwise damaged in any way.
•
Take it to an authorized service center
•
Do not disassemble the charger; take it to an authorized service center when service or repair is required.
Incorrect reassembly may result in a risk of electric shock, electrocution or fi re.
•
Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric
shock. Removing the LED Light Accessory will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V household electrical power. Do not attempt to use it
on any other voltage. This does not apply to the vehicular charger.
VARIABLE SPEED TRIGGER
To turn the tool on, squeeze the trigger. To turn the tool off, release the trigger. The more you squeeze the trig-
ger, the faster the tool will operate.
FORWARD/REVERSE AND SPEED CONTROL
The forward/reverse and speed control switch (Fig. 1) determines the direction of the tool and also serves as the
variable speed control. To select full speed forward rotation, turn the switch to the far right side of the tool as shown.
To select reverse, turn the switch to the far left side of the tool as shown. Please note, reverse is always full power.
Forward rotation can be adjusted for variable speed by turning the lever between the three settings as shown in
Fig 1, switch will detent in each position.
Fig. 1
FORWARD - SPEED SETTING 1
FORWARD - SPEED SETTING 3
LED LIGHT ACCESSORY
ATTENTION: LED light accessory must be charged before fi rst use. LED light will not function until charged.
8
(included with MPF990381, MPF990501, MPF992501 and MPF990501C)
FORWARD - SPEED SETTING 2
REVERSE
MACTOOLS.COM
Publicidad
