DeWalt DW055E Manual Del Usuario página 5

2. Click (Figure
A 3
dot on the wall (Figure
the distance from the bottom of the tool to
the wall (Figure
D 2
3. At the bottom of the display window
(Figure ), view the current
A 2
measurement (Figure
keep changing as you move the tool (in
Continuous Measure mode).
4. When the bottom of the tool is positioned
at the correct distance from the wall, click
to take the current measurement on
the display window (Figure
Changing the Unit of Measure
Once the current measurement is taken, you
can change the unit of measure from decimal
ft (6.21 ft) to fractional ft (6'02"9/16), fractional
ft to meters (1.894 m), meters to inches
(74 9/16 in), or inches to decimal ft.
To change the unit of measurement, press
and hold until you see the measurement
change (3 seconds).
NOTE: If you continue to hold
measurement changes, the tool will turn off.
Re-measuring
If you need to take a new measurement,
click .
• The previous measurement (Figure
will appear above the new current
measurement (Figure
• When you are ready to take the new current
measurement, click
) to display a laser
) and measure
D 1
).
), which will
E 3
).
E 3
after the
)
E 2
).
E 3
.
Turning Off the Tool
The tool can be turned off in either of these
ways:
• Press and hold
display window clears).
• If you do not use the tool for 60 seconds, it
will automatically turn off.
Warranty
Go to www.D WALT.com for the latest
E
warranty information.
for 5 seconds (until the
E
5