Samsung WMN5870XK Guia De Instalacion página 2

Wall Bracket Assembly
1
Install the angle adjustment bracket on the wall as shown
in the figure. Make sure the word "Top" on the pull out
section of the angle adjustment bracket is facing up.
Use a carpenters level to make sure the bracket is level.
5
2 4
8
Tighten the angle adjustment bracket by using anchors
and screws ⓐ. Insert and tighten the screws in order from
① to ⑨.
If the wall in your initial installation location is not solid
enough to install the bracket, install it in nearby location
where the wall is strong enough.
Check the solidity of the wall before installation. Strengthen the wall if necessary. Do not install the bracket on a wall that is
not strong enough.
The supplied screws and anchors are for installing on concrete walls.
For plaster, marble, or steel walls, use the appropriate screws and anchors.
2
Securely fix the angle adjustment bracket to the wall. Then, pull the angle adjustment bracket forward and unfold it.
Insert the left bracket onto the angle adjustment bracket as shown in the diagram below, and then tighten with the supplied
screws ⓑ.
Repeat the same process with the right bracket.
6
1 7 3
9
How to Install the Supplied Anchors and
Tighten the Supplied Screws.
Concrete wall
Use the angle adjustment bracket as a
template to mark the screw hole locations.
Make a hole in the wall with a 9mm x
70mm (11/32in x 2.5in) drill bit at one of the
marked locations.
Clean out the hole.
Insert the supplied anchor into the hole.
Match the holes on the angle adjustment
bracket to the holes on the wall.
Insert and then tighten the screws.
 Use a drill bit of the required size. Be sure to follow the
installation instructions to avoid safety problems.