Stanley FATMAX FMHT77652 Manual De Instrucciones página 8

• The colored LEDs on the front of the Detector (Figure
GB
laser beam (Red), aligned with the laser beam (Green), or below the laser beam (Blue).
• The Laser Detection icon on the LCD screen (Figure
Detector's Reference Line is to the laser beam. The greater the number of bars in the icon, the farther
away the Reference Line is from the laser beam. If the laser beam is found within the Detector's range, the
LCD screen will also display the Digital Height Reading (Figure
the laser beam. If the laser beam is detected outside the Detector's range, OUT will appear instead of the
Digital Height Reading.
• The audible beeps, unless sound is muted.
Red
Green
Blue
Red
Move down
Green
Blue
When the Detector's Reference Line (Figure
3.
NOTE: If the top of the Detector is used as a marking location, reference the back of the Detector for the
measurement compensation value (Figure
8
Lining up the Detector's Reference Line with a Laser Beam
(Indicate whether you need to move the Detector UP or DOWN)
OUT
Move down
30 to 50 mm
> 50 mm
Detector's Reference Line is lined up with the laser beam
OUT
Move up
30 to 50 mm
Move up
> 50 mm
) indicate whether the Detector is above the
A
6
or
E 5
Laser Detection Icons
Move down Move down
20 to 29 mm 10 to 19 mm
Move up Move up
20 to 29 mm 10 to 19 mm
) is aligned with the laser beam, mark that position.
A
1
).
A 7
) will show how close the
E 6
) between the Reference Line and
E 8
Move down Move down
5 to 9 mm 1 to 4 mm
Move up Move up
5 to 9 mm 1 to 4 mm
Fast Beep
Steady Beep
Slow Beep