Removing The Gas Module - BURNHARD NERO Gasmodule Manual Del Usuario

REMOVING THE GAS MODULE

CAUTION: Only remove the gas module when the pizza oven has
cooled down completely.
1. Take the pizza stone out of your NERO.
2. Remove the chimney from the opening in the body of the pizza oven by
rotating it 180°.
3. Loosen the screws on the heat shield of the gas module and remove the
gas module from the pizza oven.
4. Turn NERO over and place it upside down on a blanket, a piece of card-
board or another soft padded surface.
5. Return the heat shield from NERO to the pizza oven, screw it down and
turn the pizza oven over again.
6. Screw the filling shaft back into its position on the body of the oven.
7. Push the fire box back into its opening.
8. Reinsert the chimney into the opening on the body by rotating it 180 °.
9. Put the pizza stone back in.
STORING THE GAS MODULE
• Allow your pizza oven to cool down completely after use and then remove
the gas module, as described under REMOVING THE GAS MODULE.
• Take the battery out of the gas module if you're not using it for an exten-
ded period.
• Store the gas module in a dry space that is protected from frost. Cover the
appliance to protect it against dirt and damage.
• Make sure that the battery compartment is always protected against
moisture.
• Always close the valve on the gas cylinder and store the cylinder out of the
reach of children.
• Also take note of the instructions for storing in the SAFETY INSTRUC-
TIONS section.
47