Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Use Optional
Spacer if Needed
Figure 5
200199-01
6. Mount sensor.
• Screw Mounting: Remove back of case by
pushing in tab on bottom with a small screw-
driver (see Figure 2). Note: Remove material
in screw holes (if needed) before mounting
with screws. Attach sensor back cover to
wall using two short screws (provided). Snap
sensor onto back cover.
• Tape Mounting: Apply foam tape to the
sensor back cover. Stick sensor back cover
to frame of door in desired position. Snap
sensor onto back cover.
7. Mount magnet. Repeat step 5 to attach magnet
(and spacer if needed) to door using two screws
(provided). Note: If using spacer, use the two
long screws (provided).
-3-
Publicidad
Tabla de contenido
