Black and Decker Workmate 500 Manual De Instrucciones página 3

588974-02,01,WM500 9/24/04
(D) 1 - Front Vise Jaw
(E) 1 - Rear Vise Jaw
(F) 2 - Wheels
Assembly:
WARNING: Wear eye protection while assembling Workmate.
Fig. 2 & 3: Frame Assembly
1. Fig. 2: Pick up the Frame Assembly (A) as shown. Place foot on the lower portion of
the assembly and push the Transition Lever to the right to unlock the unit.
2. While holding the Transition Lever in the unlocked position, lift up on the upper cross
member until it is fully extended.
3. Rotate the upper cross member toward you and push back on the lower leg
assembly shown.
4. Fig. 3: Continue to push down on the upper cross member until the unit locks in the
fully open position.
5. Note! Make sure that the locking pin, is engaged and locked into the opposite frame
hole – a click sound will be heard when locked in place.
Fig. 3: Wheel Assembly
1. Using Wheels (F), M8 Wheel Nuts (P) and Flat Washers (Q), assemble to the axles as
shown.
2. Tighten the M8 Wheel Nuts using the Nut Driver (O).
Fig. 4: Assembly of the Vise Brackets
1. Assemble the left hand Vise Bracket (C) as shown (Each bracket is stamped either
LH or RH).
2. Insert one M6 x 36.5mm Bolt (G) through the rear leg of Frame Assembly, then
through the rear of the Vise Bracket as shown. Using a Phillips screwdriver and a
Combination Wrench, tighten the M6 Lock Nut (I) onto the bolt.
3. Assemble the front leg of the Frame Assembly to the front of the Vise Bracket (C) as
shown.
4. Insert one M6 x 30 mm Bolt (H) completely through the front leg assembly and then
through the hole in the side of the Vise Bracket as shown. Thread an M6 Lock Nut
(I) onto the end of the bolt and tighten with a Combination Wrench and Phillips
screw driver.
5. Repeat for the right side (RH) Vise Bracket.
Fig. 5: Assembling the Front and Rear Vise Jaws
1. Thread the M8 bolts (J) through the mounting holes located on the top side of the
Front Vise Jaw.
2. While holding the Vise Screw and Pivot Nut up from the underside of the tilt bracket,
thread the M8 Bolt into the mounting hole in the pivot nut.
3. Tighten the M8 Bolts using the Nut Driver (O) (or Combination Wrench provided).
4. Align and install the locating boss on the underside of Rear Vise Jaw (E) with the
locating hole (larger of the two holes) on the Vise Bracket.
5. Insert the two remaining M8 Bolts (J) through the mounting holes located on the top
side of the Rear Vise Jaw and thread into the mounting holes of the Vise Brackets.
6. Tighten the M8 Bolts using the Nut Driver (O) (or Combination Wrench provided)
11:19 AM Page 3
(J) 4 - M8 Bolts
(K) 4 - Swivel Grips
(L) 2 - Spring Pins
(M) 2 - Vise Hand Cranks
(N) 2 - Snap-in Knobs
(O) 1 - Nut Driver
(P) 2 - M8 Wheel Nuts
(Q) 2 - Flat Washer
(R) 2 - Vise Screw Protectors
(not shown) 1 - Combination Wrench
2