Controls; Fan Settings; Chef Connect - Cafe QuietBoost CVW9304 El Manual Del Propietario

Controls

1 2
Delay O
Hold 3 Sec
1. Rangehood Control Panel:
is located under the front edge of the canopy. The
position and function of each control button are
noted below.
2. Fan On/Off:
On/Off switch for the fan. The fan
can be operated by pressing any of the fan setting
buttons. Hold Power for 3 seconds to activate Delay
Off feature, which automatically turns the fan off after
15 minutes. Low, Med and High buttons LEDs will
rolling blink to indicate Delay Off feature is activated.

3. Fan Settings:

Speed control for fan. Fan
speed is powered by QuietBoost™ Technology.
This unique technology is designed to minimize
ventilation noise and enhance motor efficiency for a
peacefully-quiet, odor-free kitchen. Press the button
Low for LOW speed, Med for MEDIUM speed, and
High for HIGH speed. Hold down the High button
for 3 seconds to activate the Boost speed that will
run for 15 minutes. High button LED will blink on/off
to indicate Boost feature is activated.

Chef Connect

Chef Connect Operation Bluetooth
To pair with another device:
To start the pairing process on the hood, press and hold
the Light button for 3 seconds. The backlight for all the
icons will flash until the hood is paired with the range or
other device. If the pairing is successful, the backlights of
all buttons will flash simultaneously three times and then
turn off. The hood lights and fan default sync setting will
be activated.
It will time out after 2 minutes if the pairing is not
completed, after which the pairing sequence will need to
be restarted.
To cancel pairing:
To cancel the pairing, hold the Light button down for 3
seconds and then turn off the hood.
49-2000706 Rev. 4
3
Fan Settings
Low Med
WiFi
Pairing
7
4. Light:
The control panel
5. Chef Connect:
6. IR Sensor:
7. Wi-Fi:
® Connection
Default Sync Settings:
The factory default setting for the light will be the brightest.
The factory default setting for the fan sync will be OFF.
The user can change the Default Sync Settings by
pressing and holding the Med button for 3 seconds.
This will enter the Default Settings Mode. Once in
this mode, the backlights for all buttons will blink on/
off indefinitely and the fan and light will switch to the
current Default Sync Setting, so the user knows what the
current default value is. At this time, set the light and fan
to the desired default levels. Once the user is satisfied
with the selection, press and hold the Power button
for 3 seconds. This will exit this mode. At that time the
backlights will stop blinking and the state of the fan and
light will change back to their prior state before entering
the Default Settings Mode.
4
High Light
Boost Chef Connect
To Pair
Hold 3 Sec
Hold 3 Sec
5
Off/On/Night Light switch for the LED lights.
Press the Light button to turn the lights on, again to
set the lights to night light setting, and again to turn
the lights off.
This is a Bluetooth
for use with other compatible Chef Connect enabled
products on a cooktop or range. When the device is
paired, the default sync settings will be activated upon
receiving a command from the range or cooktop. To
change the default sync setting, refer to the Chef
Connect section.
To pair devices, hold down the Light button for 3
seconds. To turn it back off, hold the button down for
another 3 seconds. See the Chef Connect section for
more details.
Remote control receiver when used
with remote control kit.
Hold down the Low button for 3 seconds
to initiate the Wi-Fi connection. The Wi-Fi indicator
light turns on when connected, see the Wi-Fi
Connect section for details.
WiFi
6
® pairing feature
5