Orbegozo PWS 1846 Manual De Instrucciones página 8

PWS 1846 - PWS 1950
DESCRIPTION
A. Speed control knob (back side)
B. Security grill
C. Metallic blade
D. Upper support
E. Height adjustment screw
F. Tube
G. Embellisher's base
H. Base
ASSEMBLY INSTRUCTIONS
Carefully unpack the contents of this carton
Fan base and tube assembly
To assemble the tube on the base, screw the bottom side of the tube to the
base with the 4 supplied screws. Unscrew the height adjustment screw and
introduce the base embellisher throw the tube, as the picture shows.
Assembling the fan and the support bar
To connect the tube to the fan's head, place the upper support in top side of the tube. Match upper support
holes with the tube's hole, put the screw in the holes and screw them with their nuts.
OPERATING INSTRUCTIONS
• Step 1: Set the fan base on a dry, level surface.
• Step 2: Please make sure the ON/Speed knob is in the off position. Plug cord into any standard AC outlet.
• Step 3: The speed is adjusted by moving the knob left or right to the desired setting (0-Off; 1-Low; 2-
Medium; 3-High)
TILT ADJUSTEMENT
To change the tilting angle of the fan head, loosen the thumb bolts, move the fan head to the desired angle,
and then re-tighten the thumb bolts.
FAN STORAGE
Your fan can be stored in the off-season either partially disassembled, we recommend using the original (or
appropriately sized) box.
If stored assembled or partially assembled, remember to protect the fan head form dust.
CLEANING AND MAINTENANCE
• Always unplug the fan before cleaning or disassembling.
• Use a damp cloth to clean the dust from the fan.
• Do not allow water to drip on or into the fan motor housing.
• Do not use any of the following as a cleaner: gasoline, thinner, or benzine.
8