Using The Device; Cleaning And Maintenance; Technical Data - Adler europe AD 4081 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 9
used because that may cause fire, electrical shock or injury.
16. Do not use the appliance for other than its intended use. The blades are very sharp!
Care is needed when handling them
17. Never blend hot oil or fat.
18. Keep fingers away from moving parts.
19. Do not cover vents.
20. Do not use with wet hands.
21. Never blend bones, ice, coffee or peanuts.
22. When changing accessories, be sure that device is NOT connected to electricity.
23. Short-time operating: Use the appliance for no longer than 50 seconds and leave it
cooled down completely before using again about 4 minutes.
24. Before first use, clean the device.
25. When cleaning device, do not use aggressive detergent, it may damage the cover of
the device.
DESCRIPTION OF THE DEVICE (Fig.1 and 4)
1a Cup lid
1c Cup
1e Engine unit
6g Cooling attachment

USING THE DEVICE

1. Ensure that all blender elements are clean.
2. Place the ingredients in the cup (1c). All the ingredients must be filled below max level marked on the bottle (Fig.2).
3. Attach the blender cutting blades (1d) to the blade cup (1c) by screwing them onto the cup (Fig.3).
4. Place the cup (1c) with the attached cutting blades (1d) on the engine unit (1e). Please note the position of the switch indicator (4f).
5. Connect the power cord to a power socket.
6. To start the blender, turn the cup (1c) to the right and turn on the button. Do not use the blender for longer than 50 seconds
continuous operation time.
7. Remove the power cord from the power socket.
6. Remove the cup (1c) from the engine unit (1e).
USING THE COOLING ATTACHMENT (Fig.6)
1. Fill the cooler stick with water up to the maximum level indicator (6g2).
2. Keep the cooler stick in the freezer until the water freezes.
3. Once the water in the cooling attachment freezes place it into the bottle and
close the lid.

CLEANING AND MAINTENANCE

Clean the blender cup and cutting blades using water with dishwashing liquid after every use.
The engine unit must not be cleaned under running water or immersed in water.
NOTE: The bottle and the bottle lid are dishwasher safe.

TECHNICAL DATA

Power: 500W
Power max.: 800W
Power supply: 220-240V~ 50/60Hz
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
1b Cup bottom
1d Blender cutting blades
4f Switch indicator
4

Publicidad

Tabla de contenido
loading

Tabla de contenido