Quartz Halogen Floodlight
The Heath
/Zenith Quartz Halogen Floodlight disperses light over a wide area, attaches to a standard junction box and is for use
®
with 120 VAC. Canopy and halogen lamp included.
FOR PROPER INSTALLATION AND OPERATION, PLEASE READ THESE INSTRUCTIONS CAREFULLY.
• Allow fixture to cool before touching. The bulb and the fixture operate at high temperatures.
• Keep fixture at least 2" (51 mm) from combustible materials. Do not aim at objects closer than 3 feet (1 m).
• Use a lamp that does not exceed the ratings for your model. Maximum ratings are: SL-5571 - 150 Watts Max;
SL-5573 - 300 Watts Max; and SL-5575 - 500 Watts Max.
Fixture Installation Instructions
To avoid Electrical Shock:
WARNING: Turn power off at the circuit breaker or
fuse.
• Follow all warnings listed on fixture.
• Grounding and installations must comply with local codes and
the National Electric Code.
• This product should be mounted on a grounded junction box and
must be used with the canopy included.
• Permanently mount the fixture to a building or pole.
SL-5571: Designed for wall or ceiling mount.
SL-5573 & 5575: Designed for wall mount only.
1. Thread aiming arm into the enclosed canopy and tighten. Apply
silicon caulk to joint for a raintight seal. Seal the remaining holes
with the enclosed canopy plugs.
2. Connect the lamp wires to the power source wiring. Secure with
wire connectors.
Black to Black
Canopy
White to White
WIRING FIXTURE
(Product May Vary from Illustration)
© 2010 HeathCo LLC
598-1121-05
To Avoid Fire or Burn Hazards:
Fixture ground to
junction box ground.
No Service Parts Available for this Product
Model SL-5571 - 150 Watts
Model SL-5573 - 300 Watts
Model SL-5575 - 500 Watts
3. Attach the canopy to the junction box (Apply silicon caulk
between canopy and junction box for a raintight seal). Keep the
fixture horizontal (within +/- 4º) so the bulb inside is horizontal.
If the bulb is not horizontal, the bulb may darken or shatter
and fail prematurely.
4. Loosen the side bolt connected to the arm to aim the fixture up
and down.
5. To avoid water entering fixture, do not aim the fixture above
the horizon.
Bulb installation and relamping
Important: Use a clean glove or cloth when handling the new
bulb. Use isopropyl (rubbing) alcohol to clean the bulb if it is
touched with your bare hands.
1. When relamping, turn power off and let the fixture cool.
2. Remove glass cover and remove the old bulb by pushing the bulb
towards the right until the left side of the bulb is clear of the left
socket.
3. To insert the new bulb push the bulb into the right socket so the
bulb is properly seated in the sockets.
4. Re-install the glass cover.
5. Reconnect the power.
Bulb
Left Socket
Contact
Lamp Head
1
2
Right Socket
598-1121-05