GM 84608731 Guia De Inicio Rapido página 4

__________________________________________________________________________________________________
Note: Use the low profile nuts provided in the kit.
9. Install and tighten the NEW supplied front shock
absorber nuts(1) to 58 Nm(43 lb ft).
10. Install the front shock absorber lower bracket bolt(1)
to bracket(2).
11. Use the EN-45059 meter to tighten the front shock
absorber lower bracket bolt(1).
a. Tighten:
i. First Pass: 100 Nm(74 lb ft)
ii. Final Pass:(25–35 degrees)
Front Leveling Kit
ALL INFORMATION WITHIN ABOVE
Date
BORDER TO BE PRINTED EXACTLY
14OC19
AS SHOWN ON 8.5 x 11 WHITE 16
POUND NON-BOND RECYCLABLE
PAPER. PRINT ON BOTH SIDES,
EXCLUDING TEMPLATES. TO BE
UNITIZED IN ACCORDANCE WITH
GMCCA SPECIFICATIONS.
IR 14OC19
Revision Auth
Init Rel – Kevin Loughlin 2974375
12. Install the outer tie rod(3) to the steering knuckle(2)
and install outer tie rod nut(1).
13. Use the EN-45059 meter to tighten the outer tie rod
nut(1).
a. Tighten:
i. First Pass: 35 N-m(26 lb ft)
ii. Final Pass:(89-95 degrees)
14. Install stabilizer bar and tighten bolts for U-brackets to
50 N-m(37 lb ft).
15. Tighten the end link bolts to 30 N-m(22 lb ft).
16. Install the underbody splash shield(4 bolts) and
tighten to 24 N-m(18 lb ft).
17. Install the front tire and wheel assembly and tighten
to 190 N-m(140 lb in)
18. Lower the vehicle.
19. Measure the front wheel alignment and adjust to spec
if necessary.
PART No.
84608731
DR
Installation Instructions
Title
Front Leveling Kit
84608731
PART No.
SHEET
4 of 12
SHEET 4 of 12