brennenstuhl WID 550 Instrucciones De Servicio página 14

Setting remote transmitters
1. Insert batteries to start setup
2. HOUSE CODE will flash for 8
seconds
3. Select HOUSE CODE (1-15) by
pressing C/F. Transmitters for each
receiver must be set to the same
HOUSE CODE and pressing SET
4. CHANNEL will flash for 8 seconds
5. Select CHANNEL (1-3) by pressing C/F
6. Humidity & Temperature will display
7. Select C or F of Temperature by pressing C/F key
- Use a different house code if your weather station
detects other signals from neighboring sources
- Factory default: house code = 01 and channel = 01
SETUP
Synchronization
Automatic Learn Function:
1. Learn function executes automatically and runs for
approximately 3 minutes when batteries are first
installed in the receiver.
2. Within these 3 minutes, receiver picks up the
temperature & humidity signals from remote
transmitter and displays the readings.
Manual-Learn (Searching for Remote Signals):
If a new remote transmitter is added
or if signal is lost (outdoor display
blinking), learn function must be
executed again.
1. Press & hold ALARM/(AM/PM)/
(C/F) for 3 seconds to start.
14
1
3,5,7
2
4
1
6
2
2
1 •
4
3