easyGO tinto Manual Del Usuario página 17

5.Seat installation for groups II (children
weighing 15-25 kg) with ISOFIX connectors
and Top Tether.
Fasten the seat with ISOFIX connectors and Top
Tether (see point 2), and follow the instructions
specified in point 4.
USING INSTALLED SEAT FOR GROUP I
(children weighing 9-18 kg)
1.Adjusting the length of 3-point car seat
harness.
To loosen the harness, press the strap length
adjuster button and pull shoulder straps
downwards (fig. 29). Warning! Do not pull by the
strap pads.
2.Seat recline adjustment.
The seat has 5 points of recline adjustment.
To adjust the recline point, pull the lever under
the front part of the base and recline the seat.
You should hear a characteristic "click" when
you properly lock the seat in the given position
(fig. 30).
3.Securing the child with 3-point harness.
Loosen the straps according to point 1 above.
Unfasten the middle buckle and disconnect the
shoulder straps (fig. 31). Move the shoulder
straps to the sides and place your child in the
seat (fig. 32). Reconnect the shoulder straps
and slide them into the middle buckle (fig. 33).
Tighten the straps by pulling on the length
adjuster band (fig. 34). Make sure that the
harness is tight, but not too tight to prevent the
child's discomfort.
REMOVING 3-POINT SEAT HARNESS AND
REMOVING THE UPHOLSTERY
Recline the seat to maximum (see: "Seat recline
adjustment"). Pull out the bottom backrest lock
and push the backrest forward (fig. 35). Loosen
the straps by pressing the strap length adjuster
button and remove the shoulder straps from the
metal buckle in the bottom part of the backrest
(fig. 36). Pull out the shoulder straps from the
openings in the backrest (fig. 37) (you can
now adjust the height of the shoulder straps by
leading their endings once again through the
appropriate pair of slots in the seat's backrest
and reattach them to the metal buckle). Lift the
upholstery and slide the strap locking buckles
though the slots in the seat (fig. 38). Remove the
crotch strap with the middle buckle by leading
the locking buckle through the slot in the seat
(fig. 39).
After removing the 3-point harness, you can
remove the upholstery (fig. 40).
To put the upholstery and harness back in place,
perform the actions presented above in reverse
order.
17