Publicidad
Idiomas disponibles
Idiomas disponibles
Equipment Required:
Fastener Kit: KA-8002-249
Wrenches: 11/16", 3/4"
Drill Bits: - None
1
Qty. (2)
BOLT CARRIAGE 7/16" - 14 X 1 1/2" GR 5
2
Qty. (2)
WASHER CONICAL TOOTH 7/16"
3
Qty. (2)
NUT – 7/16"
4
Qty. (1)
BOLT CARRIAGE 1/2"-13 X 1 1/2" GR 5
1. Thread bolt leader (9) onto end of carriage bolt (1) and insert bolt leader through reinforcing plate (7). Fish the bolt leader and
assembly through the access hole in frame and carefully pull through existing hole in frame until bolt is in position. Leave bolt leaders
attached so the hardware does not get pushed back inside the frame. Repeat for other side of vehicle.
2. Install 1-1/2" carriage bolt (4) through square hole in hitch and vehicle's tie down loop from driver's side. Install clamping block (8)
and conical toothed washer (5) and nut (6) and hand tighten to hold hitch in place.
3. Fish bolt leaders through holes in hitch's frame straps and being careful not to push bolt assemblies back into frame channels,
raise hitch's frame straps up to vehicle's frame, remove bolt leaders and install conical toothed washers (2) and nuts (3).
4. Tighten all bolts, referring to torque table on instruction sheet.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005, 2007, 2008 Cequent Towing Products
Installation Instructions
HONDA ACCORD
Drawbar Kit:
3592
Drawbar must be used in the
RISE position only.
TIE DOWN LOOP
Tighten all 7/16 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Tighten all 1/2" fasteners with torque wrench to 75 Lb.-Ft. (102N*M)
4 cylinder
Do Not Exceed Lower of Towing Vehicle
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (91Kg) Max Tongue Weight
Wiring Access Location: PC3
8
5
Qty. (1)
WASHER CONICAL TOOTH 1/2"
6
Qty. (1)
NUT – 1/2"
7
Qty. (2)
PLATE REINFORCEMENT
8
Qty. (1)
BLOCK; CLAMPING, 1-1/2" X 3"
Sheet 2 of 6
Part Numbers:
Manufacturer's Rating or
FRAME RAIL
Qty. (2)
9
BOLT LEADER
24787N
9-29-08
Form F206 Rev A 5605
24787
60953
77161
9
Rev. C
Publicidad
