Product Description; Cleaning And Maintenance - Concept RK0070 Manual Del Usuario

EN

PRODUCT DESCRIPTION

1 Lid
2 Handle
3 Kettle body
4 Supply cable base
5
6 Switch
3
4
CAUTION:
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then pouring it out.
The kettle is then ready for operation.
The kettle may only be used with the supplied base.
36
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (4), open the lid (1), and fill the appliance with
cold water within the permitted maximum only. If the water level in the kettle
is under the recommended minimum, the kettle will keep overheating and
turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle cannot
turn off automatically
2. Place the kettle on the base (4); electric contacts will get connected automatically.
Thanks to the central connector design, the kettle can turn around 360° and be
put on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (6).
1
A control light on the switch (5) signals the kettle is in operation. The kettle lid (1)
must be properly closed when water is being heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed.
Hot steam could scald you!
5. After the boiling point has been reached, the kettle will turn off automatically, and the operating light will go out.
Water heating can be terminated prematurely by moving the switch (6) to the off position.
2
6. Remove the kettle from the base (4) and use the hot water.
7. If you want to reheat the water you have just finished boiling, wait for approximately 30 seconds before reactivating
the switch (6).
8. The kettle filter captures all potential impurities while pouring water.
Note: It is not a sign of a defect when a small amount of water droplets appear on the kettle base (4). It is a small amount
of condensed steam, which deactivates the kettle thermostat.

CLEANING AND MAINTENANCE

Warning!
5
Prior to each cleaning operation disconnect the lead-in cable of the appliance from el. socket! Prior to start any handling
6
operation, make sure that the appliance is cooled down!
Use only a wet rag for cleaning surface of the appliance, do not use any cleansers or hard things which could damage
the surface!
Never clean the appliance under running water, never flush it and never immerse the appliance into water!
Scale removal
During common use water impurities are deposited. Use commercially available agents for scale removal (observe
manufacturer's instructions).
Note: Remove the deposits regularly, once a week as a rule – periodicity depends on water hardness and on frequency
of kettle use. The deposits reduce efficiency and service life of the appliance materially.
RK0070 | RK0071 RK0070 | RK0071
EN
Fig. 1
37