Mannesmann 15033 Instrucciones De Servicio página 18

2. Clean air should always be used to ensure trouble-free operation of pneumatic tools. Build-
ups of corrosion, dust and dirt will impair performance and cause technical problems.
3. The service units provided with the tool, including a filter, a pressure release valve and oil
dispenser, remove humidity and dirt from the air, regulate operating pressure and supply the
tool with oil.
4. Insufficient operating pressure reduces your tool's performance and revolution speed.
Always maintain the correct operating pressure of 6-7 bar and a sufficiently powerful
compressor with a suitably large reservoir.
5. Bear in mind pressure decreases (losses) in the supply line.
6. This for example amounts to an existing air volume of 1 m³ and a hose with a length of 10m
and a width of 10mm ca. 1.4 bar. In order to obtain a tool operating pressure of 6 bar, the
adjusted pressure must be set to ca. 7.4 bar in order to compensate for pressure loss in the
hose.
7. Maintain your pneumatic tool regular intervals.
8. Supply lines, connections and couplings must be of an adequate size, as these define
impact speed and performance.
9. Avoid excessive tool operating pressures, as overloading will shorten its life-cycle.
2 Year Warranty
The warranty period for this appliance begins on the date of purchase. You will need to show us
the purchase date by producing the original purchase receipt.
We guarantee the following during the warranty period:
• Free removal of possible problems.
• Free replacement of all parts, where these are defective.
• Completely free expert service (i.e. free maintenance by our specialist staff)
This is conditional on the fault not being due to inappropriate treatment.
Please refer any further enquiries or quality issues directly to the manufacturer:
Brüder Mannesmann Werkzeuge GmbH
Abt. Reparatur-Service
Lempstr. 24
42859 Remscheid
Tel: +49 2191/37 14 71
Fax: +49 2191/38 64 77
mail: service@br-mannesmann.de
Obsolete Tools and Environmental Protection
If your pneumatic tool has been used so intensively on a daily basis that it must be replaced, or
if you have no further use for it, please consider the environment. Pneumatic tools should not be
disposed of in normal household refuse, but can be disposed of in an environmentally friendly
way.
You can also ask your BRÜDER MANNESMANN representative.
GB - 17