Connection; Connection-Wire Diagram; Test - koban KDP-33 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KDP-33
Infrared Motion Sensor

CONNECTION:

Warning. Danger of death through electric shock!
-Must be installed by professional electrician.
-Disconnect power source.
-Cover or shied any adjacent live components.
-Ensure device cannot be switched on.
-Check power supply is disconnected.
--Please move the upper cover with anti-clockwise whirl as per the
diagram on the right.
--Connect the power and the load according to the connection-wire
diagram.
--Fix the bottom on the selected position with the inflated screw.
--Install back the upper cover on the sensor, then you could switch
on the power and test it.
CONNECTION-WIRE DIAGRAM (See the right figure)

TEST :

-Turn the TIME knob anti-clockwise on the
minimum (10s).Turn the LUX knob clockwise on
the maximum (sun).
14
The wires come in
and out from the
bottom
The wires come in
and out from the side
www.grupotemper.com

Publicidad

Tabla de contenido
loading

Tabla de contenido