Ego Power+ CS1610 Manual Del Usuario página 38

NOTICE:
Small directional arrows are engraved in the saw chain and the side cover
(Fig. 27a). When looping the saw chain onto the sprocket, make sure that the direction
of the arrows on the saw chain corresponds to the direction of the arrow on the
side cover. If they face in opposite directions, turn over the saw chain and guide bar
assembly (Fig. 27b).
27a
Guide Bar Slot
Sprocket
4. Place the guide bar on the mounting surface by sliding the guide bar slot over the
alignment flanges, making sure that the tension adjusting pin is inserted in the
lower hole in the tail of the bar (Fig. 27a).
5. Replace the side cover and lightly tighten the side-cover knob by turning it
clockwise. The bar must be free to move for tension adjustment.
6. Tension the chain by following the chapter "ADJUSTING THE CHAIN TENSION".
NOTICE:
To extend the guide bar life, invert the bar occasionally.
CAUTION:
38
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1610/CS1610-FC
Alignment Flange
Tension Adjusting Pin
The saw chain must be properly tensioned before using.
Rotation
Direction Arrow
27b
Cutter Direction