Yard force YF22-HWT Manual Del Operador página 12

WARNING! Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow flame
or sparks in the area where the engine is refueled or where gas is stored. Avoid repeated or
prolonged contact with skin or inhalation of vapour.
WARNING! Gasoline with up to 10% ethanol (gasohol) is acceptable.
Do not use unapproved gasoline, such as E15 and E85.
1. Clean surface around gas filler cap to prevent contamination.
2. Loosen gas filler cap slowly. (see Fig.5)
3. Carefully pour fuel into the tank. Avoid spillage.
4. Prior to replacing the gas filler cap, clean and inspect the gasket.
5. Immediately replace gas filler cap and hand tighten. Wipe up any spillage.
NOTE: It is normal for smoke to be emitted from a new engine after the first use.
TO SET THE HEIGHT OF CUT
CAUTION Before you set the height of cut, stop the engine. Wait for all moving parts to stop. Allow
engine to cool and disconnect the spark plug wire.
The height of cut can be set from 11⁄2 to 3 in. [38-76 mm]. Recommended cutting height for the average
yard is 2 in.[51 mm].
1. Use the T-Wrench, found in a parts bag, to loosen the (2) set screws. (See Fig. 6)
NOTE: The (2) set screws are only on one side of the trimmer head. If you don't see the set screws,
check the opposite side. Both set screws need to be loosened to change the height of the cut.
2. Slide the trimmer head up or down for desired height of cut.From position 1 to position 7, the cutting
heights range from 1.5" to 3" (38-76mm), 0.25" between each position.
3. Tighten both set screws to 2.6 - 3.7 foot-pounds (3.5-5 Nm).
ASSEMBLY
Fig. 6
Height of Cut Positions
Set Screws
Trimmer Guide
12
0.25"
Trimmer Head
T-Handle Wrench
Hotline: 1-866-902-9690