Viqua D4 El Manual Del Propietario página 9

Installation
5
• Insert the reference card
between controller and
mounting bracket.
Note: Outlet must be
protected by a Ground Fault
Circuit Interrupter (GFCI).
9
2
• Insert the lamp/sleeve
assembly into chamber,
screw hand tight.
Note: Over tightening will
break the sleeve.
9
6
• Connect power cord to
controller.
• DO NOT connect the power
cord to the GFCI outlet at this
time.
• Some lamp assembly may be
required. If wires are on
outside of glass, lamp/sleeve
are separate. Proceed to step
7. If wires are inside glass,
skip to step 9.
10 10
1
• Align connections by rotating
the ring clamp and install the
lamp plug.
7
1
2
3
• Install the sleeve bolt with 2
new O-rings to the sleeve.
11 11
• Insert the safety cap.
v
8
1
UV
1
2
Hg
2
• Install the lamp into sleeve
and hand tighten.
Note: Over tightening will
break the sleeve.
12 12
• Connect power.
• Open all faucets and turn on
water supply. Inspect for any
leaks.
Note: Outlet must be
protected by a Ground Fault
Circuit Interrupter (GFCI).