Gas Requirements - Bastilipo EG-NE-10K Manual De Instrucciones

CAUTION
PLEASE READ CAREFULLY THE
FOLLOWING SAFETY GUIDELINES
BEFORE OPERATION
Do not use the patio heater for indoors, as it may cause personal
Ÿ
injury or property damage.
This outdoor heater is not intended to be installed on recreational
Ÿ
vehicles and/or boats.
Installation and repair should be done by a qualified service
Ÿ
person.
Improper installation, adjustment, alteration can cause personal
Ÿ
injury or property damage.
Do not attempt to alter the unit in any manner.
Ÿ
Never replace or substitute the regulator with any regulator other
Ÿ
than the factory-suggested replacement.
Do not store or use gasoline or other flammable vapors or liquids in
Ÿ
the heater unit.
The whole gas system, hose, regulator, pilot or burner should be
Ÿ
inspected for leaks or damage before
use, and at least annually by a qualified service person.
Ÿ
All leak tests should be done with a soap solution. Never use an
Ÿ
open flame to check for leaks.
Do not use the heater until all connections have been leak tested.
Ÿ
Do not transport heater while it's operating.
Ÿ
Do not move the heater after it has been turned off until the
Ÿ
temperature has cooled down.
Keep the ventilation opening of the cylinder enclosure free and
Ÿ
clear of debris.
Do not paint the radiant screen, control panel or top canopy
Ÿ
reflector.
Control compartment, burner and circulation air passageways of
Ÿ
the heater must be kept clean.
Frequent cleaning may be required as necessary.
Ÿ
The LP tank should be turned off when the heater is not in use.
Ÿ
Check the heater immediately if any of the following occurs:
Ÿ
- The heater does not reach temperature.
- The burner makes popping noise during use (a slight
noise is normal when the burner is extinguished).
- Smell of gas in conjunction with extreme yellow tipping of
the burner flames.
The LP regulator/hose assembly must be located out of pathways
Ÿ
where people may trip over it or in area where the hose will not be
subject to accidental damage.
Any guard or other protective device removed for servicing the
Ÿ
heater must be replaced before operating the heater.
Adults and children should stay away from high temperature
Ÿ
surface to avoid burns or clothing ignition.
Children should be carefully supervised when they are in the area
Ÿ
of the heater.
To change the gas cylinder in a amply ventilated area, away from
Ÿ
any ignition source (candle, cigarettes, other flame producing
appliances, ...);
Hose/ Regulator connection and
Regulator / Cylinder connection
To check that the regulator seal is correctly fitted and able to fulfill
Ÿ
its function showed as photo right;
To not obstruct the ventilation holes of the cylinder housing;
Ÿ
To close the gas supply at the valve of the gas cylinder or the
Ÿ
regulator after use;
In the event of gas leakage, the appliance shall not be used or if
Ÿ
alight, the gas supply shall be shut off and the appliance shall be
investigated and rectified before it is used again;
To check the hose at least once per month， each time the cylinder
Ÿ
is changed， or each time before long time no use. If it shows signs
of cracking, splitting or other deterioration it shall be exchanged for
new hose of the same length and of the equivalent quality;
The use of this appliance in enclosed areas can be dangerous and
Ÿ
is PROHIBITED;
Read the instructions before using this appliance. The appliance
Ÿ
must be installed in accordance with the instructions and local
regulations.
For connection of hose and regulator,and connection of regulator
Ÿ
and hose, please refer to photo showed above.
HEATER STAND AND LOCATION
The heater is primarily for outdoor use only.
Always ensure that adequate fresh air ventilation
is provided.
Ÿ
Always maintain proper clearance to non
protected combustible materials i.e. top 100
cm and sides 100 cm minimum.
Ÿ
Heater must be placed on level firm ground.
Ÿ
Never operate heater in an explosive
atmosphere like in areas where gasoline or
other flammable liquids or vapors are stored.
Ÿ
To protect heater from strong wind, anchor
the base securely to the ground with screws.

GAS REQUIREMENTS

Use propane, butane or their mixtures gas
Ÿ
only.
Ÿ
The pressure regulator and hose assembly to
be used must conform to local standard
codes.
11
ENG