User Servicing Instructions; Cleaning And Maintenance Instructions - Sears Kenmore 127. 36700310 Manual De Uso

FULLY INSERT THE BLADES.

UNPLUG THIS PRODUCT FROM THE POWER SUPPLY BEFORE SERVICE.

IF THE POWER CORD IS DAMAGED, IT SHOULD BE REPLACED BY THE MANUFACTURER,
ITS AGENT LICENSED OR QUALIFIED FOR SERVICE TO AVOID A HAZARD.
SAVE THESE INSTRUCTIONS

USER SERVICING INSTRUCTIONS:

This product employs overload protection (fuse). A blown fuse indicates an overload or short-
circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse by
following the servicing instructions below (follow product marking for proper fuse rating). If the
replacement fuse also blows, a short-circuit may be present and the product should be
discarded, or call the following customer assistance number to arrange for possible product
repair: 1-886-877-1889.

Grasp plug and remove it from the receptacle or other outlet device. Do not unplug by
pulling on cord.

Select a suitable tool such as a small flat screwdriver.

Open the fuse access cover by sliding or prying it open.

Carefully remove the fuse by prying it out from one end
or by turning the fuse holder over.

Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse.
Gently press the new fuse into the slot at both ends. Do
not press on the glass tube.

Close the access cover until it is flush with the plug face.

Do not replace the plug. It contains safety devices (fuse, AFCI, LCDI) that should not be
removed. Discard the product if the plug is damaged.
Tips:

Do not overexert when replacing the fuse or damage may occur.

If it's hard to close the access cover, make sure the fuse is fully inserted.

CLEANING AND MAINTENANCE INSTRUCTIONS:

During Season Care:

Before cleaning, be sure to turn off and unplug the fan.

Keep fan clean. Carefully wipe the unit with a soft, damp cloth.

DO NOT immerse the fan in water and never allow water to drip into the motor housing.
Please be very careful when cleaning near the fan motor.

Never use gasoline, benzene or thinner. This will damage the surface of the fan.

After cleaning, be sure to dry the fan completely with a cloth or towel.
After Season Care:

Before putting the fan in storage, clean thoroughly, cover with a plastic bag and store it in
a cool and dry place. We recommend using the original or a properly sized box.
Maintenance:

Do not attempt to repair or adjust any electrical or mechanical functions of this unit. Doing
so will may cause damage to the fan or personal injury.
- 3 -