Celestron 47007 Manual De Usuario

Personal Weather Station
with Wireless Remote Sensor
Model # 47007
Thank you for purchasing this Celestron
personal weather station. Please read the
instructions prior to using it and we hope you
will have many years of pleasure using it.
Set Up Power for the Receiver
For optimum performance, please place the Receiver away from
metal and other sources of interference such as mobile phones,
TVs, computers, appliances, etc. If the Receiver stops showing the
display or dims, replace the batteries.
Set Up the Power & Make Settings for the Wireless Remote Sensor
Remove the small screw (center area of center image) from the rear door of the sensor with a small
screwdriver. Insert two AAA batteries (user supplied) as indicated in the sensor (see right image). Set
the switch to "1" (for Channel 1), push/toggle the button so readings will be shown in "C"
(Centigrade) or "F" (Fahrenheit). Then push the button "TX" and hold it a couple of seconds which
will transmit the RF signal from the sensor to the Receiver. The Sensor itself will display the outside
temperature and humidity (see left image). Replace the rear door of the sensor by installing the small
screw to hold it in place.
The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to
communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely
(hanger part on left of center image) to any surface that is secure or it can stand up (if in an area
without wind, etc.) by folding out the small stand (right part of center image).
All manuals and user guides at all-guides.com
Open the battery compartment door on the rear of the Receiver.
Then insert two "C" batteries (user supplied) with polarity as
indicated in the battery compartment. After installation, put the
battery compartment door back on.