Breaking In The Pump - Husky H2G3TK Manual Del Usuario

ATTACHING HOSE AND QUICK COUPLER
See Figures 3 - 5.
Make sure the air compressor is off and unplugged.
Rotate pressure regulator knob fully counterclockwise.
Apply thread sealing tape to both ends of the hose and
to every male threaded end (Fig. 3).
Insert thread end of hose into open end of air outlet
fitting on compressor. Use open-end wrench to tighten
securely (Fig. 4).
NOTE: Be careful not to allow threads to become
cross-threaded.
Attach female quick coupler to other end of hose and
tighten securely (Fig. 5).
WARNING:
Do not attach any tools to the open end of the hose until
start-up has been completed.
Firmly grasp the open end of the hose; hold facing
away from yourself and others.

BREAKING IN THE PUMP

See Figures 6 - 7.
Check and tighten all bolts, fittings, etc.
Turn the pressure regulator knob fully clockwise to
open the air flow.
Place the switch in the OFF position and plug in the
power cord.
Open the drain valve completely.
Turn the air compress ON ( l ) and run the air
compressor for 10 minutes to break in pump parts.
Place the switch in the OFF position.
Close the drain valve.
THREAD
SEALING
TAPE
All manuals and user guides at all-guides.com
ASSEMBLY
HOSE
PRESSURE
REGULATOR
HOSE
Fig. 3
12
AIR OUTLET
FITTING
THREAD
SEALING
TAPE
THREAD
SEALING
COUPLER
TAPE
REGULATOR
PRESSURE
SAFETY
GAUGE
VALVE
KNOB
AIR OUTLET
Fig. 4
HOSE
Fig. 5
TANK
PRESSURE
GAUGE
ON/OFF
SWITCH
Fig. 6
DRAIN
VALVE
Fig. 7