Husky H2G3TK Manual Del Usuario página 19

WARNING:
Never load the cartridge without first checking that the
protector (A) is working correctly.
Never connect the nailer/stapler to the compressor
without first checking the proper functioning of the
protector (A).
Do not use the tool if it operates without pulling the
trigger. Personal injury may result.
Do not use the tool if it operates while lifted from the
work surface. Personal injury may result.
3) Release the outer part of cartridge (C) from the locked
position, pressing lever (D) (Fig. 15).
4) Slide the outer part of cartridge (C) downwards (Fig. 16).
5) Insert a set of nails/staples (H) in the housing of the
cartridge (L) checking correct positioning (Fig. 17/A-
17/B).
6) Slide the outer part of cartridge (C) upwards, pressing
lever (D) at the same time (Fig. 18).
7) Lock the outer part of cartridge (C), releasing lever (D).
Make sure that the cartridge is securely fastened (Fig. 19).
8) Connect the nailer/stapler to the compressor as
explained at chapter "OPERATION - USING THE AIR
COMPRESSOR".
9) Use the compressor regulator to adjust to the
recommended working pressure for the task to be
performed.
10) The nailer/stapler is now ready for use. Before
proceeding with the actual work, it is advisable to
practice on a test piece in order to check penetration
of the nails/staples: use a piece of reject wood of a
thickness exceeding the length of the nails/staples.
Rest point (A) of the nailer/stapler against the surface
of the wood and press trigger (B). If the nail/staple
does not penetrate to the depth required, set the air
pressure to a higher value WITHOUT EXCEEDING
THE MAXIMUM PRESSURE INDICATED IN THIS
MANUAL (Fig. 22).
11) SINGLE SEQUENTIAL MODE
This mode requires the trigger to be pulled each time
a nail/staple is driven. The tool can be actuated by
depressing the protector (A) against the work surface
followed by pulling the trigger.
The trigger must be released to reset the tool before
another nail/staple can be driven.
WARNING:
An improperly functioning tool must not be used.
Do not actuate the nailer/stapler unless it is placed
firmly against the work piece.
All manuals and user guides at all-guides.com
NAILER/STAPLER
L
19
A
C
D
C
L
H
Fig. 17/A
C
C
D
Fig. 14
Fig. 15
Fig. 16
H
Fig. 17/B
D
Fig. 18
Fig. 19