Uline H-1119 Manual De Instrucciones página 6

DISPLAY – MOUNTING AND INSTALLATION CONTINUED
DISPLAY START-UP
The display shows a number of messages on start-up
once it is plugged in.
Display shows:
• Program version: "P-", then number
• TOM-Net address: 'ad", then 51 or 21
• Last number displayed when power was
disconnected: Number, ("00" if first-time start-up.)
• Error message if display is set as a duplicate master:
'ed"
OPTIONAL DISPLAY SETUP
To enter setup options, make sure display is unplugged.
Hold down one of the (+) push buttons and plug the
display back in. Release the push button when display
shows "UP."
Set display update delay:
• Display shows "UP" followed by the current delay
time in seconds, (ex. "00"). Press the (+) button to
increase the delay one second at a time.
• After three seconds without pushing the button, the
set display sleep time appears.
Set display sleep time:
• Display shows "SL" followed by the current setting in
minutes. (The display shuts off after a set period of
time with no button pushes.) Press the (+) button to
increase the delay before the indicator goes into
sleep mode one minute at a time.
• After three seconds without pushing the button, the
display flashes and the number change appears.
PAGE 6 OF 18
(See Figure 17)
1-800-295-5510
1
2
3
4
Set display flashes when number changes:
• Display shows "FL" followed by the current setting
showing number of flashes. Press the (+) button to
increase the number of times the display will flash
when the number changes one flash at a time.
• After three seconds without pushing the button,
the display shows "CS" and saves new settings to
memory.
INSTALLING ADDITIONAL INDICATORS
• See instructions included with H-2769 or H-4665.
uline.com
Delay Time (seconds)
Range: 00–29
Sleep Time (seconds)
Range: 00–99
Number of Flashes (when changing)
Range: 00–09
Figure 17
0421 IH-1119