Publicidad
Idiomas disponibles
Idiomas disponibles
ALTERNATE OPERATION
To turn off the flare without cycling through the light
pattern, press and hold the ON/OFF button for two
seconds. Two LEDs will flash five times and then turn off.
When ready to operate again, press the ON/OFF button
and it will return to the last flash pattern that selected
before turning off.
BATTERY INSTALLATION AND REPLACEMENT
1.
Remove all three compression screws using the
included hex wrench and remove the top of the
flare. (See Figure 1)
Figure 1
Battery
18 LED bulbs (per flare)
Temperature range
DOT & traffic
safety compliance
Weight
Dimensions
PAGE 2 OF 6
OPERATING INSTRUCTIONS
TECHNICAL INFORMATION
SPECIFICATIONS
2 AA alkaline batteries included
Replacement battery specs may vary
5 mm, 20,000 MCD, 100,000 hour life
14°F to 158°F
U.S. DOT (FMCSA) 49 CFR § 392.25 & 393.95 (g) (prohibits the
carrying of any flame-producing flare on any commercial
motor vehicle (CMV) transporting explosives; any cargo of
flammable liquid or flammable compressed gas, whether
loaded or empty; or any CMV using compressed gas as a
motor fuel).
MUTCD Type A (flashing) and Type C (solid on)
NFPA 1901 Standards for Traffic Safety; Section 6.7.3
Miscellaneous Equipment
2 lbs. 12 oz.
5.25 x 5.75 x 5.5"
2. Install two AA batteries making sure to align them
with the correct (+) & (–) placement, as indicated
inside the battery compartment. (See Figure 2)
Figure 2
AA Batteries
3. Replace the top of the flare and firmly tighten all
three housing screws. If they are not tightened
enough the flare will not be waterproof.
NOTE: As an option to standard alkaline
batteries, AA rechargeable NiMH batteries
may be used.
1-800-295-5510
uline.com
POWER DURATION
#1 – Rotate
#2 – Quad Flash
#3 – Alternating Blink
#4 – Quick Flash
#5 – SOS Rescue (Morse Code)
#6 – Steady On
#7 – 3 LED Light
RUN TIME
30+ hours
30+ hours
20+ hours
40+ hours
60+ hours
15+ hours
40+ hours
0521 IH-7931
Publicidad
