Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY INSTALLATION
Indoor Alarm Receiver
The Indoor Alarm Receiver requires 3 AA batteries (not supplied) to operate.
For reliable, long-lasting performance, use only high quality alkaline batteries.
To install batteries:
1.
Push the release tab and lift off the battery compartment cover.
2.
Insert 3 new AA batteries, matching the polarity markings (+ and -) shown inside the
battery compartment.
3.
Replace the battery compartment cover.
Alert Sensor
The Alert Sensor requires 3 AAA batteries (not supplied) to operate.
For reliable, long-lasting performance, use only high quality alkaline batteries.
To install batteries:
1.
Using a small Phillips
compartment cover, and then lift off the cover.
2.
Insert 3 new AAA batteries, matching the polarity markings (+ and –) shown inside
the battery compartment.
3.
Replace the battery compartment cover and screw it back into place with the
previously removed screws.
Doorbell
WARNING! This product contains a button/coin cell battery. If the button/coin cell battery is swallowed,
it can cause internal chemical burns in as little as two hours and lead to death. Dispose of used
batteries immediately. Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention.
Australia: If you think batteries might have been swallowed or placed inside any part of the body,
immediately call the 24-hour Poisons Information Centre on 13 11 26 for fast, expert advice and go
straight to the nearest hospital emergency room.
The Doorbell is powered by a CR2025 battery (supplied).
To install the battery:
1.
Using a small Phillips
compartment cover.
2.
Rotate the battery compartment cover counter-clockwise until the arrow
with the Unlock position
3.
Place the new CR2025 battery in the battery compartment with the positive (+) side
facing up.
4.
Replace the battery compartment cover rotating clockwise until the arrow
with the Lock position
screwdriver, remove the two screws securing the battery
®
screwdriver, remove the screw securing the battery
®
and lift off the cover.
and fasten with the previously removed screw.
aligns
aligns
EN
5
Publicidad
Tabla de contenido
