Using The Appliance - Philips SCD510 Manual De Instrucciones

EngliSh
8
Unplug the baby unit and make sure your hands and the unit are dry when you insert the non-
rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries. (Fig. )
 Insert four non-rechargeable batteries (Fig. ).
Note: Make sure the + and - poles point in the right direction.
 Reattach the lid. (Fig. 5)
Note: When the batteries are low, the battery light on the baby unit flashes red.
parent unit
operation on rechargeable batteries
The parent unit comes with two NiMH AAA 900mAh batteries.
Charge the parent unit before you use it for the first time or when the battery light indicates that
the batteries are low. The battery light flashes red when the batteries are low. The battery light starts
to flash red 30 minutes before the batteries are completely empty.
Note: If the batteries are completely empty, the parent unit automatically switches off and loses contact
with the baby unit.
1 Remove the lid of the compartment for the rechargeable batteries (Fig. 6).
 Insert the rechargeable batteries (Fig. 7).
Note: Make sure the + and - poles of the batteries point in the right direction.
 Reattach the lid (Fig. 8).
 Put the small appliance plug in the parent unit and put the adapter in a wall socket (Fig. 9).
5 Leave the parent unit connected to the mains until the batteries are fully charged.
During charging, the battery light lights up red continuously.
,
When the batteries are fully charged, the battery light lights up green continuously.
,
- When you charge the parent unit for the first time or after a long period of disuse, switch it
off and let it charge continuously for at least 10 hours.
- Charging normally takes 8 hours, but it takes longer when the parent unit is switched on while
charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
- When the batteries are fully charged, the parent unit can be used cordlessly for at least
24 hours.
Note: When the parent unit is charged for the first time, the operating time is less than 24 hours. The
batteries only reach their full capacity after you have charged and discharged them four times.
Note: When the parent unit is not connected to the mains or even when the parent unit is switched off,
the batteries gradually discharge.

using the appliance

1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
 Press and hold the on/off button 3 on the baby unit until the green power-on light goes
on. (Fig. 11)
Note: The power-on light always lights up green, even when there is no connection with the parent unit.
The nightlight lights up briefly and then goes out again.
,
The battery light T lights up briefly and then goes out again. (Fig. 12)
,
All manuals and user guides at all-guides.com