Fitting The Sensor, For Size 6 To 8 - Aventics RAK Instrucciones De Servicio

AVENTICS
6.4

Fitting the sensor, for size 6 to 8

The sensor for Drehantrieb size 6 to 8 is fitted onto the Drehantrieb
housing by using a sensor holder and a mounting plate. Sensor,
holder and mounting plate are ordered and supplied separately.
Two sensors with sensor holder can be fitted. To use sensors, a
swivel arm with magnet is required.
Fit one or two sensor holders (1) onto the mounting plate (3)
1.
using the fixing screw (2) supplied.
Fit the mounting plate (3) to the rotary actuator (5) using the
2.
fixing screw (4) supplied.
Fig. 9: Fitting the sensor, for size 6 to 8
Position the sensor in the sensor holder and connect it
3.
according to Fig. 8 on page 44.
Adjust the position of the sensor, if required, by loosening the
4.
fixing screw of the sensor holder (2). Lock the screw when the
holder is in the desired position.
| RAK | R402005099–BDL–001–AB
4
3
45
1
2
5
00133643