TATRA TIM.2504G.A Manual Del Usuario página 24

EN
03. ICE CUBE MAKER INSTALLATION
SELECTION OF THE PRODUCT LOCATION
ATTENTION! Prevent direct contact of the product with heat sources and do not place it in
the vicinity of heat sources.
20cm
ELECTRIC POWER CONNECTION
The mains voltage and frequency must always match the voltage and frequency indicated on
the product. If assistance in this matter is needed, please contact the nearest Frozy
authorized service center or a competent electrician.
ATTENTION! Make sure that the mains is earthed.
• The fuse of the plug socket to which the product is plugged shall be at least 10 A.
• Do not use an extension cord to operate the ice cube maker and do not plug other devices
into the same socket.
WATER USE AND CONNECTION
Frozy Ice Maker is designed to produce ice cubes of perfect size and within the perfect time.
Please keep in mind that certain factors may affect the quality of the ice produced and the
machine's component service life.
ATTENTION! Tap water:
• Shall be of potable quality,
• Shall have be optimally hard,
• Shall have minimum chlorine content.
• The optimum water filters selected for your products can be found in our authorized service
centers.
• The minimum temperature is 10°С, the maximum temperature is 30°С.
24
10cm
10cm
• In case it is necessary to place the device
on the side surfaces of electrical appliances
(which can be a heat source), leave a space of
at least 10 cm.
• If the product is placed against a wall, the
distance between the side and back of the
product and the wall should be at least 20
cm.
• Do not place objects in front of the
ventilation filter that may obstruct the air
intake.
• Do not place the product in outdoor areas.
This product is intended for the indoor use.