Connecting The Speakers - Pioneer HTP-072 Manual De Instrucciones

Connecting your equipment

Connecting the speakers

The receiver will work with just two stereo speakers (the front speakers in the diagram) but
using at least three speakers is recommended, and a complete setup is best for surround
sound.
Make sure you connect the speaker on the right to the right (R) terminal and the speaker on
the left to the left (L) terminal. Also make sure the positive and negative (+/–) terminals on the
receiver match those on the speakers.
You can use speakers with a nominal impedance between 6 and 16 .
Be sure to complete all connections before connecting this unit to the AC power source.
Bare wire connections
1 Push open the tabs and insert exposed
wire.
2 Release the tabs.
CAUTION
• These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric
shock when connecting or disconnecting the speaker cables, disconnect the power cord
before touching any uninsulated parts.
• Make sure that all the bare speaker wire is inserted fully into the speaker terminal. If any
of the bare speaker wire touches the back panel it may cause the power to cut off as a
safety measure.
1 2
Front right Front left
HDMI IN IN OUT
IN
1
DVD SAT/CBL GAME BD
( CD )
ASSIGNABLE
COAXIAL
ANTENNA VIDEO AUDIO
R L FRONT
AM LOOP
R
DVD IN
SAT/CBL
IN
ANALOG IN
1
(CD)
FM UNBAL
75
ASSIGNABLE
MONITOR
OUT
Surround right
Subwoofer
Center
IN
1
( TV )
ASSIGNABLE
OPTICAL
A
SPEAKERS
CENTER SURROUND SUBWOOFER
L R L
Surround left
02
02
11
En