Names And Functions Of Parts - Esoteric grandioso G1 Manual Del Usuario

Names and functions of parts

A
LOCK indicator
This shows the clock status.
When the reference frequency input (EXT IN) connector
setting is OFF
This blinks when warming up or when an error occurs. It stops
blinking and stays lit when output stabilizes.
When the reference frequency input (EXT IN) connector
setting is 1PPS or 10MHz
This blinks when warming up, when there is no input signal or
when an error occurs. It stops blinking and stays lit when locked.
B
POWER button
Press this to turn the unit on and off.
When the unit is on, the power indicator lights blue.
o When the power is turned on, the unit starts warming the
rubidium unit up to its operating temperature. It takes 10
minutes for the oscillator frequency to stabilize.
V
Turn this unit's POWER button and PREHEAT switch off
when you do not plan to use it for an extended amount
of time.
C
Power indicator
When the unit is on, this lights blue.
10
A B C D
D
Clock output indicators
These show the status of each of the 10MHz OUT connectors.
From left to right, the indicators correspond to 10MHz OUT 1, 2,
3 and 4.
The colors of the clock output indicators change as follows
according to their operation modes.
Blue: Normal mode (NOR)
Green: Adaptive Zero Ground (A.GND)
Unlit: Output off (OFF)