Electrical Connection - US Blaster USB 3451 El Manual Del Propietario

USB 3451 / 3461 - 3471 - 3481
Car Power Amplifier

ELECTRICAL CONNECTION

13 +12V
Anode of power connection terminals. Connect to the anode of car battery.
REM
Terminal to be connect with Remote cable, which comes from the source and which
controls the amplifier switching on. Applied voltage must be between 7 and 15VDC.
GND
Ground terminal. Connect to the car underpan . Keep the length of the ground cable
to a minimum.
Connect to chassis
ground of vehicle*
SPECIFICATIONS
Model
RMS Power @ 13.8 VDC
4 Ohm Stereo
2 Ohm Stereo
4 Ohm Bridged
Impedance
THD Distorsion
IMD Distorsion
Frequency response
Input Sensitivity
Input Impedance
Signal-to-noise Ratio
Channel seperation
Remote Bass Control
Crossover Network
Low Pass Filter
Bass Boost
High Pass Filter
Fuse Rating
Size (HxWxD)
© US Blaster Europe BV
USB 3451 USB 3461
4x80 Watt 4x120 Watt
4x100 Watt 4x150 Watt
2x160 Watt 2x250 Watt
20 Hz~20 KHz
4x20 A 4x20 A
65x258x468 mm 65x258x528 mm
Connect to +12Vof battery with
appropriate FUSE value.
Connect to remote
turn-on lead of
source unit.
USB 3471
2x150 Watt
2x180 Watt
300 Watt
2 Ohm
0.08%
0.08%
200 mV~6V
15K
90 dB
50 dB
0dB~+12 dB
40 Hz~250 Hz
0 dB~+12 dB
80 Hz~500 Hz
2x20 A
65x258x398 mm 65x258x468
USB 3471
2x200 Watt
2x250 Watt
400 Watt
2x20 A