Connecting To An Amplifier - Yamaha CDC-697 Manual De Instrucciones

PREPARATIONS
Connecting an Amplifier
Never plug in this unit and other components until all connections are completed.
• Before making any connections, switch OFF the power to the unit and the amplifier or other components.
• Connections should be made to the correct input terminals of the amplifier or other components.
• If the placement of this unit causes noise in other equipment, such as a tuner, separate them from each other.
1 Audio pin cable
(included)
Choose one of the ways listed below to connect this unit to your amplifier.
■ When the LINE OUT (analog) terminals of this unit are used (1)
• Be sure that the left (L) and right (R) LINE OUT terminals are connected to the corresponding (left and right) terminals of
the amplifier or other components.
• Connect the LINE OUT terminals to the CD (or AUX) terminals of the amplifier. For additional details concerning these
connections, refer to the operation instructions for the amplifier being used.
■ When the DIGITAL AUDIO OUT (OPTICAL) terminal of this unit is used (2)
• Before using this terminal, remove the terminal cover by pulling it.
• Make the connection from this terminal to the optical input terminal of an amplifier by using a commercially available
optical cable.
* Be sure to use a high quality optical fiber cable. Other cables might not function correctly.
• Be sure to attach the terminal cover when this terminal is not being used in order to protect the terminal from dust.
• Set the level of signals output into an amplifier to max by using the OUTPUT LEVEL –/+ buttons.
For Custom Installer
■ REMOTE CONTROL IN/OUT terminals
These terminals are used for custom installation system. When this unit is connected to the components for custom
installation system, you can operate this unit with the system remote control.
Connect the REMOTE CONTROL IN terminal of this unit to the output terminal of the central controller for custom
installation system.
By connecting the REMOTE CONTROL OUT terminal of this unit to the REMOTE CONTROL IN terminal of the
other component, you can also operate it with the system remote control. In this way, up to 6 components can be
connected in series.
■ RS-232C terminal
This terminal dose not support normal external component connection. This is an expansion terminal for factory use
only.
4
En
LINE OUT
R L
OPTICAL
DIGITAL AUDIO OUT
2 Optical cable
(not included)
L
R
OPTICAL
CD
DIGITAL IN
ANALOG IN
LINE OUT
R L
RS-232C REMOTE CONTROL
IN OUT
OPTICAL
DIGITAL AUDIO OUT
REMOTE CONTROL IN/OUT terminals
RS-232C terminal
Amplifier
(General model)
VOLTAGE SELECTOR
230-
240V