Resetting And Preparing For Registration - Velux VSE KLR 100 Manual Del Usuario

Resetting and preparing for registration

The skylight can be reset to its initial factory settings
and then be prepared for registration.
1
To reset the skylight, make sure that it has been closed
by inserting a pointed object in the skylight operator
cover hole marked A and pressing briefly.
2
When the skylight is closed, press with a pointed
object through the operator cover hole marked A for
at least 5 seconds. The skylight operator and other
electrical products connected to the skylight will run
briefly back and forth indicating that they are ready to
be registered.
Note: A reset removes the connection between the
skylight with its electrical products and all remote
controls. Therefore the products cannot be operated
until they have been registered in a remote control
again. To reinstate the connection between product
and remote control after reset, please refer to the
instructions in section Initial set-up.
62 VELUX
All manuals and user guides at all-guides.com
ENGLISH
A
B
A
B
min 5 sec