Frothing Milk - HAEGER CM-85B.009A Manual De Usuario

large 2 cup filter for two cups of espresso. Fill the filter using the measuring
spoon. Clean away any coffee that may remain around the edge of the
filter holder. The coffee powder could not exceed the max level in the filter
after being pressed.
9. Place the filter holder into its housing. Turn the filter holder round to the right
until you notice it is stopped. Do not force it.
10. Place cups under the outlets of the filter holder.
11. Press "coffee switch" and wait for the right amount of coffee to pour into the
cups then press "coffee switch" again.
WARNING Do not leave the coffee maker unattended during making the
coffee, as you need operate manually sometimes!
12. After finishing making the coffee, you can take out the filter holder, lock the
filter by filter lock bar and pour out the coffee residue.
13. Let them cool down completely, then rinse under running water.
IMPORTANT NOTICE
You cannot start to make espresso until the ready light glows because it
means the water temperature is not enough. To avoid water leakages from
the rim of filter holder and to ensure optimum performance, it is necessary to
clear any ground coffee from around the boiler outlet. Take care as the
area may be hot.

Frothing milk

It is advised to froth the milk after the coffee had been prepared as milk frothing
mode requires a higher temperature. After milk frothing it is necessary to wait a
minimum of 5 minutes to allow the device to cool down slightly. If the
temperature of brewing is too high, the coffee can be scalded which will cause
the coffee to have a burned and bitter taste and aroma.
Before frothing ensure the volume of the milk is adequate in the cup. Milk can
double in volume after frothing, so care should be taken when deciding the
volume of milk.
Use a heat-resistant cup for milk frothing. The cup can get very hot during
frothing.
1. Turn on the milk frothing mode by pressing steam switch. The LED control light
will start to blink. When the light starts to shine continuously the device is
ready to generate steam.
2. Rinse the steam tube by turning the steam knob anti-clockwise. Steam and
some water will come from the steam wand. Turn off the steam by turning
the steam knob to the right in clockwise.
3. Immerse the steam tube into the cup with cold milk and turn the steam knob
to the left in anti-clockwise.
Instructions for use
English
5