Barrette 34111492 Manual Del Usuario página 8

Installation For Half-Privacy Railing
1.
A half privacy railing kit creates a 42" tall railing
section. Posts are spaced 64" inside edge of
post to inside edge of post and use full length
infill boards (66" long) and rails (66
assembly (Fig. 1).
NOTE:
• Six (6) infill boards are required for a
42" high panel, and five (5) boards for 36".
• Posts are 42
little room above the top rail so that other
rail systems can attach to it if required. You
may cut
cap sit flush with the rail if desired when
transitioning between privacy panels.
• These posts can also be cut down for a
36" rail height. Cut posts down 6" for a 36"
finished rail height and post height of 36
when attaching to another rail system. You
may cut posts down 6
top flush with the top rail if desired when
transitioning between privacy panels
2.
a. Posts are designed and manufactured to
accept
bolting to surface. Be sure to use appropriate
fasteners for your installation.
b. Determine the placement of the posts by
evenly spacing them along the deck. Ensure
sufficient mounting structure exists at these
locations. Note that the maximum distance
between posts can be 64" inside edge of post
to inside edge of post See Step 5 (Fig. 9) for
reference.
NOTE:
3.
Snap a chalk line onto the mounting surface to
ensure that all posts are aligned properly (Fig. 2).
Plumb and level the posts (Fig. 3).
Secure posts into position.
4 .
Concrete application:
a
Use the post assembly to mark the holes for
the concrete anchors as required by applicable
building codes. The holes in the surface
mounting plate will allow for a max size of a
⁄ " anchor (Fig. 4).
3
8
8
⁄ " and designed to allow a
3
8
⁄ " off the post to have the top
1
4
⁄ " to have posts
1
4
⁄ " fasteners (sold separately) for
3
8
A minimum of 4" solid blocking is
required for standard installation.
However, additional structure may be
required depending on application.
Always refer to local building codes
for installation requirements.
⁄ ") during
7
8
⁄ "
3
8
64" 64"
42 ⁄ "
3
8
Deck Deck
Mounting Plate Mounting Plate
Chalk Line Chalk Line
Post Post
Level Level
Post
3 ⁄ " Hardware
8
3 ⁄
8
Concrete
Fig. 1
Fig. 2
Fig. 3
Fig. 4
" Holes