Pause Function; Recall Function - Franke FHI 754 4I ST CTX Manual De Instrucciones

Pause function

Recall function

Timer
selection of both cooking elements (the same as activation).
If the bridge function is deactivated while in operation, than both cooking elements
go to level "0" and can then be set again.
The execution of the function is only possible if at least one zone is on.
The pause condition may also be activated with cooking zone specific errors,
here, the error display is hidden. Also residual heat indication, special
messages such as A, P or no pan are hidden; the pause display has priority.
If there is a general error during the pause, the control switches off and
terminates the mode.
Activating the Pause function
Press the sensor (B), the led to the left of it lights on.

All displays show the symbol "II" and all operations are locked.

While the Pause function is active:
• Any Timer (also Egg-timer) set before the pause will be stopped during the pause
and continue when pause mode is quitted.
• A selected booster or heat up time automatic function is terminated.
• Residual heat calculation and maximum operation time limitations will not be
interrupted and keep on working in the background.
• Functional LED's such as Timer, multi-zone, ... keep on glowing according to their
status.
The pause mode can only be active for maximum 10 min. If the pause mode is
not deactivated within 10min the control switches off automatically.
Throughout the pause time the (A) button can be used to switch the control
off. In this case the pause mode is also deactivated.
Interruption of Pause function
• Press (B).
• Within 10 seconds press any key.
The condition before the pause mode is restored.
If the control was accidentally switched off through the main switch (A) all settings
can be restored using the recall function. After switching the control off from the
main switch the user has 6s to switch the control on again and then he has another
6s to press the pause button (B) in order to recall the settings. The recall function
can only be used if at least one cooking zone was active (cooking level >0)
independent from key lock.
Use of timer facilitates cooking by setting the time of hotplate operation.
Turning timer on
• The cooktop must be turned on and the zone where you want to set the timer
must be working.
• Press the timer's sensor ON/OFF (D), the symbol "00" blinks at the timer's
display.
The timer symbol blinks near the display at all active zones.
• Press the cursor (E) of the cooking zone where you want to set timer, the timer's
led blinks near the display.
• The timer's value is set by adjusting on the zone's cursor.
Sliding to the right the value increases, sliding to the left the value decreases in
intervals of 1 minute.
• When the finger is removed from the cursor, the timer starts to count the set time.
The cooking level is shown at the indicator.
The led near the timer's display indicates that the timer is active.
If the timer is set for more cooking zones, the zone with shorter remaining time will
be indicated by the led to the right of the zone and by the led near the timer's
27