Listening To The Radio - AEG SR 4347 Instrucciones De Servicio

4. Use / buttons to set the minutes.
5. Press SLEEP/TIME SET again in order to save the time
settings.
Transport Safety Device, CD Compartment
• Open the CD compartment (3) by pulling the lid upwards
by the tab (5).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Volume
You can set the desired volume with the VOL+/AL 1 / VOL-/
AL 2 buttons (13).
Turning device on/ off
• Press the ST/FUNC button (16) to turn the device on.
• To turn off the device, keep the ST/FUNC pressed down.
The time display will appear. Unplug the device.
NOTE:
After about 10 minute without a signal, the device will
automatically switch to standby.

Listening to the Radio

1. Select the radio mode with the ST/FUNC button (16). FM
or AM appears in the display.
2. Select the desired frequency band with the BAND/
ALBUM button (15).
VHF = FM, Medium wave = AM (Mono)
3. Tune in the desired station with the station adjustment
knob TUNING (6).
4. During FM operation, completely unwind the dipole
antenna (2). Change its position to improve the reception.
5. An aerial is integrated into the device for the reception of
AM stations. The machine can be aligned to the station
by turning it. In this frequency band programs are trans-
mitted in "mono" only.
Playing CDs/MP3
This is how you play a CD
1. Select the CD mode with the ST/FUNC button (16). The
following will appear in the display "- - - -".
2. Open the CD compartment (3) by pulling the lid upwards
by the tab (5).
3. Insert an audio CD with the printed side facing upwards
on to the central cone so that the CD clicks into place
and then close the lid of the CD compartment.
4. After a few seconds the total number of songs/tracks is
shown in the display.
NOTE:
In the case of CDs in MP3 format the number of folders
is briefly displayed at first.
5. The CD will play from the first title. The elapsed play time
and the message " " respectively " MP3" are shown in
the display.
6. In order to remove a CD, please press the button (8),
open the CD compartment and lift the CD out carefully.
Always keep the CD deck closed.
NOTE:
• If a disc is inserted the wrong way around, respectively
if no disc is inserted, then the message "- - - -" will blink
and "NO" appears on the display.
• Playback of CDs produced by the user cannot be
guaranteed due to the large variety of software and CD
media available.
Description of the CD buttons
(7)
You can briefly interrupt and resume playback using this but-
ton. The symbol " " and the elapsed playtime will blink in
the display. Pressing again continues playback.
/ (10)
With you can jump to the next or previous track etc.
• If the button is kept pressed down, the machine starts to
search through the tracks.
The button can be used as follows:
Press once = This starts the current track again from the
beginning.
Press twice = This jumps back to the previous track.
Press three times= This plays the song before etc. If the but-
ton is kept pressed down, the machine
starts to search through the tracks
(8)
The CD stops.
MODE (9)
• In stop mode for programming any order of tracks (see
the section on "Programmed Play").
With a running audio CD or a CD in MP3 format:
Press once = (the emits a fixed light) the current
track is repeated continuously.
Press twice = (the ALL emits a fixed light) the
whole CD is played continuously.
Press three times = the display RAND appears in the display.
All the titles are replayed consecutively in
a random order.
English
37