Clearing The Memory; Memory Full; External Antenna - FAAC XR2 433 C Manual Del Usuario

5. Release all buttons.
6. Press the button on the new radio control that
has just been memorised twice in succession.
The associated output on the receiver activates.
■ MEMORISING RC RADIO CONTROLS
1. Press the button of the receiver that corresponds
to the channel that you wish to associate with
the radio control until the relative LED starts to
flash slowly (DL1->channel 1, DL2->channel
2). When the button is released, the LED con-
tinues to flash for 20 seconds, during which the
codes can be memorised by pressing the relative
buttons of the radio controls.
2. Whenever a code is memorised, the LED of the
receiver lights up steadily for 2 seconds and then
flashes for 20 seconds.
3. If no code is memorised while the LED is flashing,
after 20 seconds the LED switches off to indicate
that the procedure has ended.
4. To memorise additional radio controls at a later
stage, repeat the procedure from step 1.
■ MEMORISING RC RADIO CONTROLS
REMOTELY
1. Press buttons P1 + P2 for at least 5 seconds on a
radio control that has already been memorised
and then release them.
2. Within 5 seconds, press and release the button of
the radio control that has already been memo-
rised to activate the learning phase on the same
channel on the receiver.
3. Press the button on the new radio control within
5 seconds. In the case of multiple radio controls,
repeat this step for each one within 5 seconds
of each other.
■ MEMORISING DS RADIO CONTROLS
1. Set the required combination of the DIP switches
on the radio control (avoid setting them to all
On or all Off).
2. Press the button of the receiver that corresponds
to the channel that you wish to associate with
the radio control until the relative LED starts to
flash slowly (DL1->channel 1, DL2->channel
2). When the button is released, the LED con-
tinues to flash for 20 seconds, during which the
following step should be carried out.
3. Press and release the button of the radio control
that you wish to memorise. Make sure that the
flashing LED of the receiver becomes steady
XR2
for 2 seconds and then flashes again for 20
seconds, during which it is possible to memorise
another radio control with a different DIP switch
combination.
4. Whenever a code is memorised, the LED of the
receiver lights up steadily for 2 seconds and then
flashes for 20 seconds.
5. If no code is memorised while the LED is flashing,
after 20 seconds the LED switches off to indicate
that the procedure has ended.
6. To memorize other radio controls, it is possible
to set a DIP switch combination that has already
been memorised or repeat the procedure for new
combinations.

4. CLEARING THE MEMORY

This deletes all the radio codes for both channels
of the receiver.
Press and hold button SW1 or SW2 until both LEDS
DL1 and DL2 turn on steadily (after approximately
10 seconds).

5. MEMORY FULL

If in step 1 of the memorisation procedure, the
LED turns off instead of continuing to flash for 20
seconds when the button is released, it means that
the memory is full and it is not possible to memorise
any more codes.

6. EXTERNAL ANTENNA

To connect the external antenna (accessory) to
terminal board J3 with the receiver powered off:
1. Remove the antenna wire supplied.
2. Connect the coaxial cable as shown in the figure.
04 532357 - Rev.A