TechGrow Humi Dual Pro Manual página 8

Operating the techgrow Humi Dual Pro:
When the humidity in a room drops below the set
value (setpoint), the humidifi er will be activated
(right socket). When the humidity in the room
reaches above the set value (setpoint),
the dehumidifi er will be activated (left socket).
Example:
The humidity "set" is at 60%.
The humidity "hys" is at 3%.
The current humidity value in the room is for ex-
ample, 63%, that is 3% higher than the humidity
set, so the humidifi er is deactivated. All LED lights
are now switched off .
Humidify
The humidity slowly drops to 60%: nothing
happens.
Only when the value drops below the humidity
"set" minus the hysteresis, the humidifi er will
be activated. In this case, the humidifi er will be
activated at 60% - 3% = 57%. The LED will now
switch to red.
The humidity level will now rise and when the
value reaches 60% + 1% = 61%, the humidifi er
will be deactivated again. The red LED will now
switch off .
Dehumidify
The humidity will now slowly rise to 63%: nothing
happens.
Only when the value rises above the humidity
"set" plus the hysteresis, the dehumidifi er will be
activated.
In this case, the dehumidifi er will be activated at
60% + 3% = 63%. The LED will now switch to red.
The humidity now drops. When the value reaches
60% - 1% = 59%, the dehumidifi er will be
deactivated again. The red LED will now switch
off .
Meaning of the LED
• Light detected: light indicator (under the PTB).
• Dehumidify: Dehumidifi er is active.
• OK: indicates that the humidify lies
between set+hys and set-hys.
Humidify: Humidifi er is active.
•
All manuals and user guides at all-guides.com
Operating and adjusting the Humi Dual:
All settings are done with the Push & Turn Button
(PTB). By pushing the button you will enter the
set-up menu. An arrow will appear on the left side
of the display =>.
When activating the Humi Dual Pro the
following will appear on the display:
After a few seconds the start screen is shown:
Here you can see all data relevant to the Humi
Dual Pro at a glance.
By keeping the PTB pressed down in this startup
screen for at least fi ve seconds, the RH min/max
values are reset and set to the current
measurement value.
Enter the menu by briefl y pushing the button:
This naturally only shows the values of connected
sensors.
Without connecting an S-2 or S-4, the CO2 value
will not be shown.
By rotating the PTB in the setup menu, you can
place the arrow in front of the various sensor val-
ues. Press the PTB once to fi nd out more about
this specifi c sensor. Only the min/max values are
indicated for "TMP" and "CO2" sensors:
TechGrow
Humi Dual
Pro-Series
Software v. 1.x
RH = 47%
RH set 50%
RH +/- 3%
Min 43% Max 57%
TMP = 25.5 C
=> RH = 32%
CO2 = 549 ppm