How To Operate The Machine; Position Of The Handle For Operation; How To Control The Machine; How To Start/Stop The Machine - Alto CLARKE FM-1500HD Libro De Instrucciones

Figure 7
Figure 8
Apply pressure to lock
Aprete la palanca para
bloquear
Presser le levier pour
verrouiller
Figure 9
Page 16

HOW TO OPERATE THE MACHINE

WARNING:
CAUTION:
NOTE: You must have training in the operation of this machine
before you use this machine.
Lift the lever to unlock the handle. Lower the handle to the best
position. Bend your arms and keep your back straight. To
fasten the handle, press down on the lever with your foot. Hold
the handle against your body for the best control. See figure 7.

How To Control The Machine

NOTE: Make sure you hold the handle with both hands.
The side to side movement of the machine is controlled by
raising the handle and pressing down on the handle. To move
the machine to the left, press down on the handle slightly. To
move the machine to the right, raise the handle slightly.

How To Start/Stop The Machine

WARNING:
The switch to start and stop the machine is activated by the
interlock switch and the levers under the handle grips. See
figure 8. To start the machine, follow this procedure:
1. Lower the handle.
2. Lock the handle in the best position for operation. See
WARNING:
NOTE: Make sure you hold the handle with both hands.
3. Push the interlock switch, and apply pressure to the
levers.
NOTE: Hold the handles loosely for the best control of the
machine. Too much movement makes the machine difficult
to control.
WARNING: Water solutions or cleaning materials used
CLARKE TECHNOLOGY Operator's Manual FM-1500HD, 1700HD, 2000, & 2300
Machines can cause flammable materials and
vapors to burn. Do not use this machine with
or near matches, fuels, grain dust, solvents,
thinners, or other flammable materials.
This machine will operate only on the AC fre-
quency and electrical voltage shown on the
nameplate. Make sure you have the correct
frequency and voltage before connecting the
power cord to an outlet.
POSITION OF THE HANDLE
FOR OPERATION
Never start a polisher when the handle is in
the vertical position.
figure 9.
Control the safety interlock switch
with hands only.
with this type of machine can leave wet ar-
eas on the floor surface. These areas can
cause a dangerous condition for the opera-
tor or other persons.
Always put CAUTION signs near the area
being cleaned.